AC, Furnace & Plumbing Services in St. Charles, MO

Responded to no cooling complaint on 10+ year old unit located at ground level. Performed diagnostic temperature measurements using digital thermometer, recording supply air temperature of 73.5°F and abnormally high discharge line temperature of 654°F, indicating potential compressor failure or refrigerant system issue. Advised customer to shut off AC system immediately to prevent further damage and keep fan running for air circulation until repairs can be completed.

Replaced failed hard start kit and capacitor on outdoor air conditioning unit. Removed corroded components from electrical compartment, installed new parts from truck stock, and verified proper system operation. Unit tested and confirmed cooling functionality upon completion.

Responded to callback for cooling system not maintaining set temperature on 10+ year old unit located in side yard. Upon inspection, found heavily corroded capacitor terminal with significant rust buildup and oxidation, compromising electrical connection and system performance. Replaced failed capacitor and verified proper electrical connections. System tested and confirmed cooling to setpoint with normal amperage draw and temperature differential across coil.

# HVAC Service - No Cool 10+ Responded to no cooling call where outdoor unit was running but indoor blower failed to engage. Upon arrival, performed diagnostic testing on the blower motor assembly located in the basement air handler system. Using multimeter, confirmed blower motor had failed electrically and was preventing air circulation through the system. Removed and disassembled blower assembly housing to access the motor. Replaced defective blower motor with new unit, reassembled blower housing, and reinstalled into air handler. Verified proper electrical connections, tested motor operation across all speed taps, and confirmed adequate airflow through the system. Cycled system through complete cooling operation to ensure outdoor unit and indoor blower now functioning in proper sequence. System restored to normal cooling operation with no further issues detected.

Responded to no-cooling complaint on ten-year-old outdoor AC unit mounted on brackets. Upon inspection, found evaporator coil severely frozen with heavy frost accumulation, confirmed by thermal readings of 53°F at the coil surface while thermostat indicated 78°F indoor temperature with setpoint of 75°F. Diagnosed frozen coil condition likely caused by restricted airflow or low refrigerant charge; unit requires further evaluation after complete thaw to determine underlying cause and necessary repairs.

Responded to emergency no-cooling call for 2013 residential AC system. Upon arrival, performed diagnostic inspection of outdoor condenser unit and indoor air handler components. Inspected refrigerant lines, electrical connections, and system operation. Documented system configuration with photos showing copper refrigerant line set, air handler installation, and condensate pan assembly. Identified issue preventing proper cooling operation and provided homeowner with repair recommendations to restore climate control functionality.

Responded to no cooling call on 10+ year old outdoor unit located on elevated platform at side of home. Upon arrival, performed electrical diagnostics using clamp meter to test voltage and amperage at the unit. Measurements indicated system was not receiving proper power or compressor was not operating within normal parameters. Documented electrical readings and equipment conditions with photos for service records.

Performed comprehensive diagnostic evaluation of residential air conditioning system following concerns raised by previous contractor regarding system condition and recommended repairs. Conducted thorough inspection of evaporator coil, refrigerant lines, electrical components, and air handler assembly. Measured and documented system amperage readings, inspected coil assembly for proper operation, and evaluated overall system integrity including refrigerant line connections and support brackets. System found to be functioning within normal operating parameters with no critical issues requiring immediate attention or replacement.

Completed comprehensive cooling maintenance on two 13-year-old air conditioning systems. Performed standard tune-up procedures including inspection of electrical connections and control components in outdoor junction box with TITAN capacitor, verified proper operation of condenser units, cleaned and serviced both systems to manufacturer specifications. Both units tested and confirmed operational with no deficiencies noted.

Responded to no cooling complaint on 8-year-old residential outdoor unit. Upon arrival, performed diagnostic inspection of condenser system and verified clearance measurements between unit and building exterior, confirming adequate airflow spacing per manufacturer specifications. Documented equipment condition and installation positioning with photographic evidence showing unit mounted on foundation with proper electrical disconnect present. System evaluated for cooling operation and common failure points associated with no-cool conditions on units of this age.

Responded to no-cooling complaint on single HVAC system. Upon arrival, found Trane thermostat displaying 84°F actual temperature while set to 78°F cooling mode, indicating system was not maintaining setpoint. Verified thermostat had power and was properly configured in cooling mode with scheduled programming active. Inspected Lennox furnace/air handler unit located in basement utility area and confirmed proper installation and accessibility. Troubleshot thermostat communication and system operation to restore cooling functionality.

Responded to a clogged floor drain in basement that resulted in significant flooding throughout the utility area. Performed jetting service from roof access point to clear the blockage and restore proper drainage. Successfully cleared the obstruction, allowing standing water to drain and preventing further damage to furnace, water heater, and laundry equipment.

Completed comprehensive tune-up service on outdoor AC condenser unit. Performed thorough inspection of control board and electrical connections, verified proper wiring configuration and component operation. Cleaned condenser coils showing algae buildup on exterior fins, inspected fan assembly and top grille for proper operation, and confirmed unit is operating within normal parameters on concrete pad with adequate clearance.

Completed preventive maintenance tune-up on two residential air conditioning units for Home Depot service agreement. Upstairs unit was reported as not cooling properly, requiring additional diagnostic evaluation beyond standard maintenance procedures to identify cooling deficiency and determine necessary repairs.

Completed comprehensive cooling system tune-up on 3-year-old outdoor AC unit. Performed electrical diagnostics using digital multimeter to verify proper voltage and amperage readings, measured system temperatures, and inspected all internal components including copper refrigerant lines, insulated suction line, and electrical connections. All measurements fell within manufacturer specifications, and unit showed normal condensation levels indicating proper operation.

Performed comprehensive cooling system tune-up on single outdoor condensing unit. Upon inspection, found evaporator coil heavily soiled with accumulated debris, dust, and organic matter restricting airflow. Removed top panel to access coil assembly, documented condition with photos, and verified electrical readings using digital multimeter. Cleaned coil fins, removed debris buildup, and inspected refrigerant lines showing normal weathering patina consistent with unit age.

Completed preventative maintenance cooling tune-up on a 2-year-old Lennox EL18XCV524-230A01 air conditioning system containing 7 lbs 13 oz of R-410A refrigerant. System was operating properly upon arrival and remained in good working condition throughout the service. Performed comprehensive inspection of outdoor condenser unit, verified electrical connections, checked refrigerant charge levels, and confirmed all operational parameters were within manufacturer specifications for the 208/230V unit.

Responded to LED light fixture malfunction with aluminum wiring. Verified and tightened connections at wall switch and traced wiring to junction box in attic where new switches and lights were previously installed. Tightened all connections at junction box to resolve intermittent operation. Recommended light fixture replacement if issues persist.

Replaced failed compressor on Emerald brand outdoor condensing unit and performed thorough cleaning of condenser coils. Unit tested and verified operational upon completion, with all components functioning within manufacturer specifications.

Completed cooling system tune-up on U10 air conditioning unit located at rear of property. Performed comprehensive maintenance including inspection of finned coil assembly, verified proper operation of 40/5 μF dual capacitor, cleaned accumulated debris from condenser coils, and confirmed all electrical connections were secure. Unit tested and operating within normal parameters upon completion.